Cisco SPA Adapter Configuration Guide

This article describes the configuration of Cisco SPA adapters with the Cisco SPA112 taken as an example.

Accessing the web interface

• Connect the adapter to the network and find the IP address using Netscan.• If the IP address of the SPA112 is unknown, lift the handset and dial ****, followed by 110# after the prompt. The IP address will be voiced to the user.• The default username and password should both be admin.

Registration

Once logged into the SPA112, select the Quick setup tab in the top left corner.

• Proxy: SIP domain from the WebPanel
• Display name: any, as it will only appear on calls that terminate to other Mightycall customers
• User ID: found in the WebPanel
• Password: found in the WebPanel

Click Submit in the lower-left corner of the SPA112 admin UI when done.

Once the equipment is done saving the configuration, select the Voice tab at the top of the interface. Line 1 should now show as Registered.

Dial plan

3-digit extension dial plan: (*xxx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.)

4-digit extension dial plan: (*xxxx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxxS0|xxxxxxxxxxxx.)

Voice Tab

Navigate to Voice > Line 1

Make note of the red arrows, and confirm your adapter’s configuration matches the changes marked.

• NAT Keep Alive: yes
• Network Jitter Level: very high
• SIP 100REL Enable: no
• SIP Port: anything of 5xxx (xxx will be the Ext number for this phone).
• Enable G729a and/or G711u codecs

• Proxy and Outbound proxy: Mightycall domain from the WebPanel
• Use Outbound Proxy: yes
• Proxy Redundancy Method: Based on SRV Port

Subscription information should be filled with the data from the WebPanel

• Display name: any, e.g. extension
• Password: from the WebPanel
• UserID: the phone number
• Auth ID: ID from the WebPanel, and if used, Use Auth ID should be set to yes

SIP configuration of the SPA112

Navigate to SIP > Voice.

• RTP port Min: 30000
• RTP Port Max: 50000
• RTCP Tx Interval: 10

To configure Voicemail, navigate to Voice > Line 1 configuration, copy the same value in the Proxy field and paste it within the Mailbox Subscribe URL field:

Star Codes

The SPA-112 has several star codes available. Several have been tested and have been documented below.

Bonus: Call transfer

Call transfer can be a challenge when it comes to analogue phones. Since it is not as obvious as with the SIP phones, here is a small guide on how to transfer a call if using an analog phone with an adapter:

1. Have a call already established
2. Press the flash key on the phone
3. User should now hear a dial tone
4. Dial the number you wish to transfer to
5. Once the call connects, the user may announce the transfer to the destination party
6. Pressing flash again will join the two calls, allowing all three parties to speak as if conferenced
7. The user may now hang up to complete the transfer